It's a little late for that! I gave up trying to repair the file system on that partition and just reformatted it. So however many programs will fit in 500GB is how many programs I lost. I think the Hopper fills up partitions in order, so the bad one was the 2nd so I believe it was completely...

Even with no OTA channels, it still won't make it through one movie without at least one crash and reboot. I hope this stops when it has the satellite again.

Yeah, it worked for me too when this same thing happened on my 1.5TB disk on a 722. I simply repaired the bum partition and the 722 mounted it just fine. IIRC the bad partition was empty and I saved all my recordings, with possibly a few lost and gone forever. Back then as now all partitions...

Well my friends, I can't even delete the old channels without plugging in the OTA adapter and rebooting. Doing that now. OK; the H3 rebooted faster than expected. I had 67 channels in there and I removed them all pending my decisions on an antenna. I am now about 20 mi farther from the...

That is an excellent idea. My OTA adapter is currently unplugged because I have no antenna on this house. Yet. Need to delete those channels.

I suffered the disappearance of my 6TB Seagate on my H3 a few months ago. The old/original H3 was replaced without fixing that, but an older EHD from my 612 days worked fine on the "new" H3. So I decided there was something amiss with my 6TB Seagate and I attempted to repair it. I...

Well, this is annoying as hell. Recall that I don't have an aligned dish yet. (A longer mast just arrived.) I've been watching prerecorded programs, but I can't get through a single 2-hr movie without the Hopper crashing and rebooting. Has anybody seen that behavior without the satellite?

Ahem. The Joey's 54 remote somehow went from "working" to dead overnight, and new batteries fixed that. :oops: The Hopper's 54 remote somehow became unpaired but I located my 40.0 UHF 2G and discovered that and fixed it. The Hopper wanted to update the remote. Don't know what needed updating...

Thanks, Bobby, for these detailed instructions which I have printed out. No, I did not mix up the remotes and yes they are both 54's and they were both working as of last night when I unplugged the H3 and J3 to bring them to my new house. Why in heck would they stop working when the dish...

Well, I can no longer check my firmware version since I moved my Hopper and Joey from my old house to new, and the remotes no longer work! (They worked fine last night.) My install this morning failed due to lack of a longer J-tube mast. Idiots! Why do they even come up with a whiff of a...

Apparently I've been away too much. Do you have a URL to the post where you described what happened?

That's not many compared to 16 + 2 + 3 (if they're part of PTAT) channels in real time. I guess I hardly needed that many, so maybe. My J3's used to do that too. But now I just get a DHCP failure and nothing happens. The Ethernet jack is literally useless unless you plug it into the 2nd...

Can existing H3 hardware support a streaming-only business model? I'm still seriously annoyed that I can't use my J3 using Ethernet-only, so I suppose the answer is "No".

I haven't tried this on my Hopper, but on my 722 EHD it most assuredly has to be owned by root:root. I found that out the hard way by using the GUI on... I think it was Scientific Linux which is a now defunct redistribution of RHEL. In any case, the screen manager, whatever it was, was not...

Dish chat fixed the issue with DishAnywhere. All I needed to do was log out and re-activate and it picked up the new receiver.