swap tv1 and tv2

[ktirons]

​

My niece was over yesterday, and somehow switched tv1 to tv2. I have tries everything and cannot get it to switch back. I have the DVR625 receiver. The only way i can control tv1 is in single mode. HELP!

 

[DishTechPA]

How is your receiver connected to your tv1? Coax or RCA cables (red, white, and yellow)?

 

[sethwell]

My niece was over yesterday, and somehow switched tv1 to tv2. I have tries everything and cannot get it to switch back. I have the DVR625 receiver. The only way i can control tv1 is in single mode. HELP!

Hit the "mode" button on the front panel behind the door. You may have to confirm this at the tv with the remote. It's been a while since I had a 625.

Sent from my iPhone using SatelliteGuys

 

[DishTechPA]

Hit the "mode" button on the front panel behind the door. You may have to confirm this at the tv with the remote. It's been a while since I had a 625.

Sent from my iPhone using SatelliteGuys

I think the op put it in single mode to allow him to function the receiver from tv1 location as he has the tv2 feed at both locations. I wondered about RCA cables bc if his niece for some reason disconnected the RCA's from the receiver, it is easy to reconnect them to the tv2 side by mistake.

 

[MattG@DISH]

I think the op put it in single mode to allow him to function the receiver from tv1 location as he has the tv2 feed at both locations. I wondered about RCA cables bc if his niece for some reason disconnected the RCA's from the receiver, it is easy to reconnect them to the tv2 side by mistake.

This is my guess as well, happens all the time

 

[pabeader]

did you try pressing the 'swap' button?